Rock Hard 4x4™ Steering Stabilizer / Tie Rod Clamp for 1-1/2" OD Tie Rods [RH-9003]

Fits Tie Rods with out Outer Diameter of 1-1/2"

Replace your embarrassingly weak and vulnerable factory steering stabilizer/tie rod clamp with our heavy duty CNC machined clamp.

Our clamp uses the same locking collar and camp theory as our world famous Sports Cage systems. Once secured to your tie rod our clamp will give you a lifetime of use. It's guaranteed to last longer than your tie rod!

NOTE: Not designed for factory steering stabilizer. This is designed for an aftermarket steering stabilizer with a 1/2" ID sleeve. The included grade-8 bolt is too large for factory steering stabilizer sleeve. You can press out that sleeve however and press in a 1/2" ID sleeve to use our clamp.

Deflecting Design
Unlike your factory clamp that acts like a rock catcher, our rounded clamp allows you to skid and slide over the obstacle. This prevents bent tie rods and worn ball joints. You are actually increasing the lifespan of your steering components with this simple upgrade.

The factory tie rod clamp is made from a thin plate that actually protrudes down past your tie rod. This allows it to catch on rocks and other trial debris. Hit hard enough or enough times and it will rotate out of position. This causes strain on your tie rod and steering stabilizer. Not to mention it's held in place by thin u-bolts that once bent after the mounting plate twists cannot be reused.


Strength
CNC machined from 1020 DOM (drawn over mandrel) means unstoppable strength. You aren't going to break this tie rod clamp

Ease of Installation
Simply unbolt your factory tie rod clamp, install ours in same location, tighten hardware, high-five your buddies.



What comes in every kit:

• Tie Rod / Steering Stabilizer Clamp
• Hardware
• Installation Instructions

Three Reasons Why:

• Deflecting design
• 1020 DOM Steel strength
• Installs in minutes

---

FAQ:
How secure is the RH4x4 locking collar?
If we didn't believe 100% in our collar design we wouldn't run it in our own rigs. It's proven design provides an unbreakable joint and you can feel confident it will keep you and your passengers safe for a lifetime of trail use.

Is any welding required?
No. Our locking collars allow for a DIY no-weld, truly bolt-in install.

What finish is available?
RH4x4 steering stabilizer / tie rod clamps ship powdercoated black with a semi-smooth, semi-gloss finish.

Where is this mount made?
This product, like all RH4x4 parts, was designed, developed, tested, manufactured, and if applicable, powdercoated, and shipped in the USA. And we don't mean the 75% legal standard to be able to say Made in USA. We are 100% Made in the United States of America!

Product: Lifetime
Coating (if applicable): Due to varying climates and individual use, we cannot offer a warranty on powdercoating.